Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
fester:staticip [2016/06/11 13:00] – created dan | fester:staticip [2017/06/24 18:19] (current) – [Configuring Static IP Addresses Via The FreeNAS GUI] add link-multiple NICs on same subnet dan | ||
---|---|---|---|
Line 43: | Line 43: | ||
{{: | {{: | ||
- | This is because multiple interfaces on the same subnet is an invalid configuration. | + | This is because multiple interfaces on the same subnet is an invalid configuration. |
===== Configuring Static IP Addresses Using The FreeNAS Console Setup ===== | ===== Configuring Static IP Addresses Using The FreeNAS Console Setup ===== | ||
Line 55: | Line 56: | ||
{{: | {{: | ||
- | Input the number that corresponds to the NIC you wish to configure in “Select an interface (q to quit):” (1). | + | * Input the number that corresponds to the NIC you wish to configure in “Select an interface (q to quit):” (1). |
- | + | | |
- | Input **n** for “Delete Interface? (y/n):” (2). | + | |
- | + | | |
- | Input **n** for “Reset network configuration? | + | |
- | + | | |
- | Input **n** for “Configure interface for DHCP? (y/n):” (4). | + | |
- | + | | |
- | Input **y** for “Configure IPv4? (y/n):” (5). | + | |
- | + | | |
- | Give the NIC a name if you wish at “Interface name:” (6). If you don’t want to give it a name then leave it empty and press the “Return/ | + | |
- | + | ||
- | Type in the static IP address you require at “IPv4 Address:” (7). | + | |
- | + | ||
- | Now enter the subnet mask of the private network at “IPv4 Netmask:” (8). | + | |
- | + | ||
- | The console should confirm that the configuration has been saved with an “OK”. | + | |
- | + | ||
- | If you don’t need or use IPv6, then just type **n** at “Configure IPv6? (y/n):” (9). | + | |
{{: | {{: |