Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
charger [2019/11/23 15:44] – [Materials] dan | charger [2019/11/23 16:38] (current) – [Disassembly] dan | ||
---|---|---|---|
Line 37: | Line 37: | ||
==== Disassembly ==== | ==== Disassembly ==== | ||
Begin by disassembling the charging base. The bottom metal plate is held on with six Phillips-head screws and one 3/32 hex-head screw. | Begin by disassembling the charging base. The bottom metal plate is held on with six Phillips-head screws and one 3/32 hex-head screw. | ||
+ | |||
+ | Once the metal plate is removed, you'll see the circuit board. | ||
+ | |||
+ | The two screws that held in the circuit board, also fastened it to the charging contacts, so they' | ||
+ | |||
+ | ==== Re-assembly ==== | ||
+ | Cut two pieces of your primary wire about 6" (150 mm) long, strip the ends, and crimp on small ring terminals to one end of each. | ||