Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revisionLast revisionBoth sides next revision | ||
| charger [2019/11/21 15:02] – created dan | charger [2019/11/23 15:44] – [Materials] dan | ||
|---|---|---|---|
| Line 24: | Line 24: | ||
| * Panel-mount micro-USB extension (e.g., https:// | * Panel-mount micro-USB extension (e.g., https:// | ||
| * Fine-gauge (20 ga. or smaller) primary wire | * Fine-gauge (20 ga. or smaller) primary wire | ||
| - | * One 5mm green LED (optional) | + | * One 3mm green LED (optional) |
| * Small crimp-on ring or fork terminals | * Small crimp-on ring or fork terminals | ||
| + | * https:// | ||
| ==== Tools ==== | ==== Tools ==== | ||
| You'll also need the following tools: | You'll also need the following tools: | ||
| Line 33: | Line 34: | ||
| * Drill | * Drill | ||
| * Screwdrivers | * Screwdrivers | ||
| + | * 3D printer (optional) | ||
| ==== Disassembly ==== | ==== Disassembly ==== | ||
| Begin by disassembling the charging base. The bottom metal plate is held on with six Phillips-head screws and one 3/32 hex-head screw. | Begin by disassembling the charging base. The bottom metal plate is held on with six Phillips-head screws and one 3/32 hex-head screw. | ||